The product adopts the standard accessories. Please refer to the product tech parameter and follow the installation steps as below:
Confirm the product install position
connect
the
drain
connect
the water inlet pipe
check
and
clean
water
testing
1. Confirm the product install position
Please refer to the product tech parameter to connect the water inlet pipe, power socket and drain tube, and check if there is enough space
for the connection.
2
.
Connect
the
drain
The drain pipe is lay in the bottom of the bathtub, with diameter 38mm. The pipe could be elbowed and extended easily. Please put the pipe
into the drain system and seal it well. Please keep the pipe running through to avoid water exhausted.
3. Connect
the water inlet pipe
The inlet pipe is withstand voltage netted pipe. Please connect the cold and hot water joints as shows on the connection. Do not reverse them.
In order to facilitate the future use and maintenance, please install a valve on each end of cold and hot water pipes.
4. Check
and
clean
Please check the connections are sealed well or not after the installation. Clean the dirt in the bathtub and open the drain to clean the bathtub.
5. Water testing
Close the drain after the bathtub is clean. Start storing water and the bathtub can be used when it isn’t leakage.
Control
panel
1 1
Control
System Connecting
Diagram
Water testing
Installation Instruction 12
WIRING DIAGRAM OF MASSAGE BATH CONTROLLER
Input Vollage: AC220-240V 50/60Hz
Max.total load : 15.8A
Waterproof : IPX5
Model: 16B40
Radio antenna
Control panel
Water level sensor
Temperature sensor
Water flow switch
of heater
Speaker 8
Ω
15w
Light
DC12V/1W
Ozone
DC12V/8W
N
L
AC power Input
Heater
AC230/Max.1.5KW
Pump
AC230V/MAX.2HP
Blower
AC230V/Max.400W
X
W
T
K
S
L
♪
1
Power on/off button
2
3
Left/Decreas key
1
2
3
4
4
Function selection key of rotary style
5 6 7 8 9
5
6
7
8
9
Radio
/
Audio icons and operation status
Ozone icons and operation status
Light icons and operation status
Surfing water pump icon and operation status
Thermostatic icon and operation status
Right/Increas key
