4
A
B
C
D
E
F
4.3 Turning on your PureDC-B1 for the first time
• Check your device’s voltage and polarity that PureDC-B1 proposes are correct.
• Make sure that all cables are correctly connected to the PureDC-B1 and powered
device. Then use the Main Power Switch to start the PureDC-B1.
• Above parameters should be set according to the recommendations of the
manufacturer of the device you want to power! EAhibrid refuses every liability for
damage to equipment due to an incorrect connected DC output voltage.
4. Overview
4.2 Back Panel Overview
A)
DC OUTPUT 5.5
＊
2.5mm
：here you connect the DC cable
B)
Main Power Switch
：ON / OFF
C)
DC OUTPUT voltage switch
：here you can choose output voltage for 9V or 12V (
please check your devices again before using )
D)
DC OUTPUT 5V USB port
：here you can use this output voltage port for 5V, and
it can be used at the same time with output voltage for 9V or 12V
E)
GND
：Ground
F)
DC INPUT 5.5
＊
2.1mm
：16.8V/2A, this is a custom made adapter for PureDC-B1,
please do not use other adapter to protect battery pack
note：our DC connector(female) is tight and slightly shallow to fit most of
DC(male) connectors
E
F
A
B
C
D
