10
Evenly control the speed of movement of the spray gun. A fast speed will give a thin coat
and a slow speed will give a thick coat.
Only apply one coat at a time. If an additional coat is required, follow the paint
manufacturer’s instructions for drying times.
If spraying small areas or objects keep the output setting low as this will avoid excessive
use of paints and will minimize overspray.
1.
2.
3.
4.
5.
7
.
6.
Helpful Hints
Fig.5
When spraying large areas or objects, it is best to use a ‘criss-cross’
pattern, either from left to right then up or down or vice-versa. This
will ensure maximum coverage (Fig. 5).
Avoid stopping and starting when spraying as this can lead to too
much or not enough material on a surface.
To ensure edges are covered, commence spraying just to the side of
area being sprayed.
CLEAN SPRAYER AFTER EVERY USE (SEE CLEANING
INSTRUCTIONS).
