SIMPLE SPRAY GUN SETUP INSTRUCTIONS
PROPER SETUP WILL MAKE THE DIFFRENCE BETWEEN A GREAT APPLICATION AND A HORRIBLE
APPLICATION.
1. Locate the Solution Flow Screw on the back of the spray gun. Part # 8
2.
Turn Clockwise to “Close” or reduce the spray pattern width, turn counterclockwise to “Open” or increase spray
pattern width.
3. Your goal is a 4 inch wide spray pattern spraying 4 inches away
from the client’s body. Test on a white (light)
towel until this setting is achieved. A wider pattern will only waste product. Spraying farther away only makes a
mess and again waste product. THIS IS THE WAY TO SPRAY!!!!!
4.
Locate the “Air Cap” (part #2) on the front of the spray gun. This is where the solution is sprayed out of the gun.
You will see a pair of “horns”. When these horns are in the vertical position, you will spray up and down. When
these are in the horizontal position, you will spray left to right.
5. Simply loosen the air cap ring (part# 1)
to adjust the horns in your preferred direction. There is no “correct” way.
What works for you is all that matters. Tighten the Air Cap Ring after adjustment.
HORNS IN HORIZONTAL POSITION) HORNS IN VERTICAL POSTION
(Spray Left to Right)
(Spray Up and Down)
Quick Tips:
Use no more than 2 oz per application. Using more is a waste of product with no benefit.
Always do two (2) coats, 1 oz each coat. A single heavy coat does not work as well as two light coats.
Best developed color results will be achieved by waiting 8-12 hours after application before first shower.
Apply very little to hands and feet, too much on these areas never works!!
Your application time should take no longer than 5 minutes; you will be able to achieve a 2-3 minute application with practice.
If you see “runs” or “beading”…you are probably going to slow…..MOVE THE GUN FASTER.
Rinse your spray gun with warm water after use, that’s all that is needed to keep your gun clean.
For great tips on using HVLP Systems in Spray Tanning visit
www.hvlptanning.com
