background image

2

SAFETY OPERATING INSTRUCTIONS

PLEASE READ BEFORE USE

NEVER under any circumstances aim the nozzle at another person or animal. 
In the event of injury occurring seek expert medical advice immediately.

The spray gun must only be used with paints and solvents that have a suitable
flash point for spraying. If in doubt consult paint or solvent manufacturer’s 
data.

Always ensure there is adequate ventilation when spraying.

NEVER spray near a naked flame, including appliance pilot flame.

NEVER use this spray gun outside when its raining.

NEVER smoke whilst spraying.

NEVER allow children to operate or play with the spray gun.

Always read the paint manufacturer’s thinning instructions before using.

Always disconnect unit from mains supply when refilling the paint container.

Before cleaning, always disconnect unit from the mains supply.

Always wear the correct protective face mask when spraying. We would also 
recommend the use of gloves, goggles and overalls.

After every use ensure that you clean your spray gun thoroughly and grease 
the fluid needle packing.

Use only genuine Earlex replacement parts.

WARNING: The substances used with this spray gun (paint, thinners etc) may
contain hazardous, harmful, explosive or corrosive materials. ALWAYS COMPLY
WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE
MATERIAL BEING USED.

Only use the unit as detailed in these instructions.

Supply Voltage

230V (50Hz)

Rated Input

800 Watts

Airflow (motor)

1550 ltr/min

Cable Length

1.7m

Hose Length

4m

Output control

690g/min (water)

Spray Gun Weight (empty)

1100gms

Container Capacity

1 Litre

Appliance Class

Class 2,
double insulated

TECHNICAL SPECIFICATION

L0199 09-04.qxd  14/2/05  10:13 am  Page 2

Summary of Contents for SPRAY STATION PRO HV 5000









Reviews: