Earlex SPRAY SYSTEM HV 1900, Operating Manual

EN

14

HV1900

WARNING

This unit is a Class II appliance which means it is 

double-insulated for your protection, no earthing wire 

is necessary.
If the supply cord is damaged, it must be replaced by 

the manufacturer or its appointed agents to avoid a 

safety hazard.
Your unit has been supplied with a supply cord fitted with a fuse plug. This is identified by the 

fuse holder in the base of the plug. Please read the following safety instructions before use.
1. If the fitted plug is cut off from the supply cord then the plug must be disposed of safely. 

NEVER under any circumstances insert such a plug into a 13 Amp socket-outlet.
2. NEVER under any circumstances use the appliance or supply cord without the fuse cover 

fitted.
This is the little cover fixed into the base of the plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring 

our helpline.
4. A replacement fuse must be rated at 5 Amps and manufactured and approved to BS 1362.
5. IF IN ANY DOUBT CONTACT A QUALIFIED ELECTRICIAN.
If you need to fit a plug to the supply cord, this should be fitted in accordance with the wiring 

instructions below, and will need to be used with a 5 Amp fuse approved to BS 1362. If in 

doubt consult a qualified electrician.
If you are using an extension lead it must be rated a minimum of 6 Amps and fully unwound. 

Do not operate with a lead rated less than 6 Amps as this will cause premature failure of the 

motor which is not covered by the guarantee.
As the colours of the wires in the supply cord of the application may not correspond with the 

coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the 

letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with 

the letter L or coloured red.