background image

Wagner Spray Tech Corporation

1770 Fernbrook Lane

Plymouth, MN 55447

© 2015 Wagner Spray Tech Corp. 

 

0815 •

 

Form No. 0P2032B

EARLEX WILL ACCEPT NO RESPONSIBILITY FOR THE USE OF THIS PRODUCT IF USED FOR ANY 

PURPOSES OTHER THAN THOSE DETAILED HEREIN.

24 Month Warranty

Earlex issues a 24 month Warranty to the purchaser effective from the date of purchase against 

defects in materials or workmanship. This warranty does not cover abuse, accidental damage, 

misuse, normal wear parts, motor brush replacement or spray gun maintenance & clean up. 

Warranty is void if repairs are made or attempted by unauthorised persons. At our option, Earlex 

will repair or replace defective parts without charge provided the purchaser return products 

prepaid to the nearest authorised service centre or to the factory. Factory returns must first 

receive a Return Material Authorisation.

In other countries please call the company where you originally purchased the product. Earlex 

will not be held liable if equipment is not used solely for the purpose it was designed. Warranty 

will become void through improper installation or operation. Any modifications to the equipment 

or deviations from the recommended procedures, accidental damage or any related action that 

impairs or abuses intended use and care of Earlex equipment will also void warranty and liability. 

In the event of rentals, this warranty period is restricted to 6 months.

PLEASE NOTE: We have done all we can to ensure that, when used correctly and in accordance with 

these instructions, the unit has a long and fault-free life. We accept no responsibility for damage 

caused by the use of incorrect or unsuitable substances, paints or liquids which have not been 

thinned correctly or which are not suitable for the surfaces to which they are applied, health hazards 

arising from a lack of ventilation when working in confined spaces or equipment which is faulty due 

to inadequate cleaning of the components after use. If in doubt, test a small inconspicuous area 

first. Always read the manufacturer’s instructions before use. Neither our warranty nor the above 

statement affects your statutory rights.

Turbine Design Registration

ECD 002307868-0003

CN 201330262602.0

US applied for

All rights reserved © 2015

Spray Gun Design Registration

ECD 002307868-0001
ECD 002307868-0002

CN 201330263092.9
CN 201330262777.1

US applied for

74657

Helpline telephone no: 888-783-2612

Fax no:  763-553-7154

www.earlex.com

Summary of Contents for SprayPort HV6002













Reviews: