HDCam
Installation Manual
EN.PM.UM11 2017022424 Earth Networks Part # 9710 Page 13 of
35
1.
Plug one end of the 200 ft Ethernet cable into the camera where the connection is
labeled “NET (PoE)”.
2.
Plug the other end of the 200 ft Ethernet cable into the power supply where the
connection is labeled “Data and Power Out.”
3.
Plug the network surge suppressor into the power supply in the connection labeled
“Data In.”
4.
Plug the 5 ft Cat 5 Network Ethernet cable into the network surge suppressor.
5.
For internet transmission, plug the opposite end of the 5 ft Cat 5 Network
Ethernet Cable into the network connection.
6.
For power, plug the power supply into an electrical outlet.
Figure 2 – Preliminary Equipment Setup