PAGE 2
Long End
holes farther
from one end
Handle Shaft
36404
Washers
31120
2” HHCS
32103
1/4-20 Lock Nut
12344
Handle Spacer
32103
1/4-20 Lock Nut
31120
2” HHCS
5.
Install handle shaft to lower handles as
shown. Using 2” bolts, washers and locknuts.
Make sure that you install the handle shaft
with the long end facing toward the sprayer.
TIGHTEN BOLTS AND NUTS NOW.
1/4-20 x
2” Hex Head
Bolt
Handle
Spacer
Upper Handles
1/4-20
Locknuts
POSITIONS
LOWER
MIDDLE
UPPER
Handle Shaft
Gun Holder
8. Next,
Install Control Rod to Valve Adapter by pressing onto the valve handle located at the back of the sprayer skirt, shown
below right.
Install the Control Rod by installing flattened end of Control Rod into Valve Adapter, shown below right.
Finally, install the Gun Holder onto the lowest bolt (closest to the sprayer TANK) and secure with a 2” bolt and locknut. Be
sure to position the Gun Holder as show below.
TIGHTEN NOW.
6.
Insert 2” bolt through upper handle, then
through handle spacer and then through other
upper handle, secure loosely with cupped
washer and 1/4-20 locknut. Now install one 2” bolt so that
it goes through the top hole in the handle shaft and secure with cupped
washer and 1/4-20 locknut.
TIGHTEN BOLTS AND NUTS NOW.
7
. Install Control Rod into the Gun Holder as shown below right.
Next install black nut protector to the short leg on
Control Rod
SPRAY TRANSPOR
T
Handle
Spacer
Upper Handles
1/4-20
Locknuts
and washers
Handle Shaft
1/4-20 x 2”
Hex Head Bolt
Gun Holder
Lowest Handle
Shaft Hole
Long End
Nut Protector
