16
Earthcore Industries
BVETTO B-Vent Gas Fireplace
08/2017
Assembly Instructions - BVETTO B-Vent Series
3.
Continue assembly of the consecutive courses of the
firebox side wall and back wall. Apply Adhesive to the top
of each layer of wall components, set the next course
above into place. Be sure to Adhesive all vertical joints of
the side wall to back wall connection when setting each
component to its mate.
(Figure 15)
Look for some Adhesive to squeeze out along the
joints of all contact surfaces as a sign that the joint is
thoroughly sealed with the approved Adhesive.
4.
When all of the firebox sidewall and backwall
components are set, check the top surface of the firebox
for level. If necessary, adjust the top surface of the box
assembly for level by inserting a shim supplied with the
unit between the lowest wall component and the top
surface of the base plate.
Any gap created under the wall components during
the Shim leveling process must be filled with Earthcore
Adhesive to fill bearing against the base plate.
5.
Begin the smoke dome assembly by setting the rear
bottom smoke dome component on top of the firebox
back wall assembly in a bed of Earthcore Adhesive. The
smoke dome component should sit flush with the back
side of the firebox assembly.
(Figure 16)
Then set the front bottom smoke dome component
across the firebox opening so that the smoke dome piece
spans the firebox opening and is flush with the front of
the firebox.
FIGURE 15
Part #20
Part #20
Backwall:
36": Part 25
46": Part 31
FIGURE 16
Smoke Dome:
36": Part #11
46": Part #13
