29
Earthcore Industries
08/2017
BVETTO B-Vent Gas Fireplace
ISOKERN Gas Log Set - Burner Installation
The BVETTO burner system must be installed in an
ISOKERN B-vent (BVETTO) fireplace and by a qualified
professional service technician. Instructions must be
followed carefully to ensure proper performance and full
benefit from the burner system. Check to be sure the
burner system is designed and labeled for the type of
gas (natural or propane gas) supplied to the fireplace.
Fireplace floor must be level, clean, and smooth.
WARNING: Failure to position the parts in accordance
with these diagrams or failure to use only parts
specifically approved with this appliance may result
in property damage or personal injury.
REFER TO THE PARTS LIST WHEN FOLLOWING
THESE INSTRUCTIONS.
ISO-IBV36 burner model shown here.
1.
MAKE SURE THE FIREPLACE GAS SUPPLY IS
TURNED OFF.
2.
Place the burner system in the fireplace. Center the
burner from left to right in the fireplace. Reference
Figure
35
for orientation.
NOTE:
Ensure the porcelainized panel is clean of all dust.
Use a clean soft cloth if necessary.
(Figure 36)
3.
Disconnect the black wires, from the main harness to
the switch box, as shown in
Figure 37
.
For units to be installed without a power vent,
follow step 4 below. For units to be installed with a
power vent follow step 5.
4.
Units without Power vent: Locate the two spill switch
wires coming out of the hole in the lower right side of the
fireplace. Connect them to the free wires now coming
from the main harness and switch box (male to female).
See
Figure 38
and the WIRING DIAGRAM TO SPILL
SWITCH in the SPECIFICATIONS section.
FIGURE 35
FIGURE 36
FIGURE 37
FIGURE 38
Disconnect black wires
Place burner
Connect spill switch wires
Ensure a clean panel
Keep clean and DO NOT
cover with embers
Spill switch wires
Main harness wire
Switch box wire
Switch box
