FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A.
This appliance is equipped with an ignition device that
automatically lights the pilot. DO NOT attempt to light
the pilot by hand.
B.
BEFORE OPERATING
, smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the
fire
department.
34
Earthcore Industries
BVETTO B-Vent Gas Fireplace
08/2017
ISOKERN Gas Log Set - Lighting Instructions
C.
Use only the control system or remote to light the
pilot. This valve will not operate if the pilot is not lit and
stable.
D.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water. Attempted operation may result in fire or
explosion resulting in property damage, personal injury
or loss of life.
Remote Lighting
CAUTION:
DO NOT attempt to light the pilot by hand.
NOTE:
If the remote does not function, and batteries
with an adequate power level are installed, refer to the
SYNCING THE REMOTE section.
NOTE:
Steps 1 and 2 may not be required if previously
done during an earlier lighting.
1.
Locate the ON/OFF switch at the front of the switch
box. Press the switch to the OFF (O) position.
(Figure
48)
2.
Locate the OFF/REMOTE slide actuator on the left rear
of the burner. Slide the actuator to the right / REMOTE
position.
(Figure 49)
3.
Locate the remote transmitter and press the ON
button.
(Figure 50)
The system will beep and the ignition
sequence will begin.
The igniter will begin to spark. After the pilot lights
andis established, the valve will automatically open and
the burner will light. Adjust to the desired setting with
the remote transmitter. See the REMOTE OPERATING
INSTRUCTIONS section for details.
NOTE:
The ignition sequence will take approximately 5
seconds.
WARNING:
If pilot fails to light within 10 seconds, press
the OFF button on the remote transmitter or slide the
OFF/REMOTE slide actuator (left) to OFF to turn off the
system. Allow five (5) minutes for any gas in the unit to
dissipate, then repeat steps 2 & 3 above.
IF YOU SMELL
GAS, SEE STEP B ABOVE
.
If the pilot fails to light after several tries, turn all
control/remote system components to OFF and contact
a qualified professional service technician.
I
O
ON
OFF
HI
LOW
Remote transmitter detail
HI-LOW
fl ame
adjustment
buttons
ON
button
OFF
button
Signal
light
OFF/REMOTE slide actuator (left rear of burner)
ON
Switch box, ON/OFF
OFF
Remote receiver
FIGURE 48
FIGURE 49
FIGURE 50
