2/2021
ISOFLAMES LINEAR BURNER
11
Burner Installation
1.
Connect all burner segments according to burner model diagram Page 11 - 15. Make sure all connections are tightly
secured.
2.
Place burner assembly in center of fireplace floor/cavity.
3.
Rotate the burner to position the gas inlet flared fitting to be on same side as the gas-supply stub coming from the gas valve.
(Not necessary for models ISF72/96LB)
4.
Remove the burner top closest to the gas-supply stub. Remove the top pan by unscrewing the two screws. This
will allow easier access and connection of flex connector to the flared fitting. This will also be used for pilot
assembly installation.
5.
Ensure the appropriate 3/8” flared fitting is connected to the gas supply stub.
6.
Connect the 12” flex connector to the gas inlet flared fitting on the burner assembly.
7.
Connect the other end of 12” flex connector to the gas-supply.
8.
Avoid creating kinks in the flex connector.
9.
Make sure all connections are tightly secured.
10.
Before replacing the removed burner top from
step 4
, locate the perforated rectangular section in the pan. Gently
remove this section along the perforations using a screwdriver or pliers.
Figure 7
11.
Insert the pilot assembly from underneath the existing burner pan to the area of the removed burner section.
Figure 8
12.
Mount the pilot assembly to the removed burner pan using the screws provided with the pilot assembly. Be careful
not to kink the pilot assembly tube as it can severely damage the pilot tube.
Figure 9
13.
Place the removed burner top back on to the orifice block and secure tightly with the pan head screws.
14.
Check appliance operation. See Burner lighting instructions Page 16.
15.
Spread glass media evenly across burner. Do not fill cavity with glass media.
16.
Make sure glass media does not obstruct pilot assembly.
17.
Optional gas logs available, shown on page 20.
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
