PW1/PW2 KIT (09/12)
Page 5
Figure 3. PW2 Assembly to Electrical Box and Base Pan
3. Install fuse holders into existing fuse holes with screws provided. Install fuses in fuse holders.
4. Install the two-pole terminal strip inside electrical box and fasten into the existing hole with
screw provided.
5. Reference Figure 3 for the location of the transformer for the SC and SD Model compressor
units, and a different location for the SCW model compressor unit.
6. Using the transformer base as a template, drill four holes in the base pan to accommodate #10-
6 screws provided. Collect and dispose of all metal shavings from drilled holes.
7. Fasten the transformer firmly to the base pan with the screws provided.
8. Route the stripped pink and gray wires form the transformer through the grommeted bottom
center hole of the electrical box and attach to the terminal strip terminals by tightening the
terminal screws onto the stripped wire ends.
9. Route the pink and gray wires with connectors and the green stripped-end wire from the
transformer through the grommeted bottom center hole of the electrical box and connect as
follows:
a. Pink wire to the collar connection of the BOTTOM fuse holder.
b. Gray wire to the collar connection of the TOP fuse holder.
c. Green wire with stripped end to the #6 high voltage terminal strip.
