FIGURE 19
LUBRICATION
WHEELS
Lubricate the wheels and bearings at least once a season
with a light oil. Also if the wheels are removed for any reason,
lubricate the surface of the axle bolt and the inner surface of
the wheel with light oil.
PIVOT POINTS
Lubricate the pivot points on the blade depth control lever
and, if applicable, the curb height adjustment lever with light
oil at least once a season.
MAINTENANCE
WARNING
IMPROPER MAINTENANCE, OR FAILURE TO CORRECT
A PROBLEM BEFORE OPERATION CAN CAUSE A
MALFUNCTION. ALWAYS FOLLOW THE INSPECTION
AND MAINTENANCE RECOMMENDATIONS AND
SCHEDULES INCLUDED WITH THIS OPERATOR’S
MANUAL.
CHECK ENGINE REGULARLY FOR LOOSE NUTS AND
BOLTS. KEEP THESE ITEMS TIGHTENED.
TEMPERATURE OF MUFFLER AND NEARBY AREAS
MAY EXCEED 150° F (65° C). AVOID THESE AREAS.
PREVENT ACCIDENTAL STARTING:
•
ENGINE MUST BE TURNED OFF AND COOL.
•
SPARK PLUG WIRE MUST BE REMOVED
FROM SPARK PLUG BEFORE CHECKING AND
ADJUSTING ENGINE OR EQUIPMENT.
FAILURE TO FOLLOW THESE WARNINGS CAN RESULT
IN SERIOUS INJURY OR DEATH.
ENGINE MAINTENANCE
Refer to the Engine Operator’s Manual included with your edger for
a detailed description of all engine-related service specifications.
REPLACING DAMAGED OR WORN BLADE:
CAUTION
SHARP EDGES OF EDGE-TRIMMER BLADE CAN CUT
YOU DURING BLADE MAINTENANCE OR ADJUSTMENT.
USE SUITABLE COVERING OVER CUTTING EDGES OF
BLADE TO PREVENT BODILY HARM.
1. Turn off the engine switch.
2. Disconnect the spark plug wire from the spark plug and set
it aside.
3. Loosen the nut holding blade in place. Remove the nut and
clamp washer.
See Figure 19.
4. Replace blade with a new blade and secure it with a clamp
washer and nut.
5. Reconnect the spark plug wire.
Operator’s Manual
Edger
16
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
