Control Functions
The information below briefly describes the function of individual controls. Operating requires the combined use of several controls
applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section.
*For engine features and controls see engine manual.
FEATURES & CONTROLS
Engine Throttle:
Located on the right side handle, as engine throttle is depressed against the handle the engine speed will
increase and start the edger blade. When engine throttle is released the engine will go back to idle and blade will stop turning.
Blade Depth Control Lever:
The blade depth control lever is located on the left side of the upper handle. It is used to control the
depth of the cut. The further forward the blade depth control lever is moved, the deeper into the soil the edger blade will cut.
Recoil Starter:
The recoil starter is used to start the engine.
Curb Wheel (Optional):
The Curb Wheel Kit offers on the go height adjustment.
CURB WHEEL (
24000
ONLY)
ENGINE THROTTLE
CHOKE
FUEL FILL
BLADE DEPTH CONTROL LEVER
ON/OFF SWITCH
ANGLE ADJUSTMENT
RECOIL
STARTER
Operator’s Manual
Edger
8
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
