Operator's Manual
Rolling String Trimmer 600050V, 600050B
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
15
how to Adjust the height of the handle
Use the knobs on each side of the handle to adjust the
height of the handle.
SEE figuRE 15.
1. Hold the handle with one hand and loosen both
knobs until the ratchet teeth are disengaged. Do not
remove the knobs.
. Move the handle up or down to the desired position,
then align the ratchet teeth. Make sure both sides of
the handle are level.
3. Tighten the knobs.
how to Set the height of the Cut
The height of the cut can be set from 1-1/
inches to three inches. The recommended
cutting height for the average yard is inches.
SEE figuRE 16.
1. Use the T-wrench found in the parts bag to
loosen the set screw shown in the figure
below.
. Set the trimmer head at the desired height.
handle
knob
Ratchet
teeth
Figure 15: Adjusting the height of the handle.
Figure 16: Setting the height of your cut.
height of Cut
Positions
height
guide
t-Wrench
trimmer head
Set Screw
waRning
bEfoRE You SEt thE hEight of thE Cut,
StoP thE EnginE. WAit foR ALL moVing
PARtS to StoP. ALLoW thE EnginE to CooL
And diSConnECt thE SPARk PLug WiRE.
