Operator's Manual
Rolling String Trimmer 600050V, 600050B
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
17
StoRAgE
When the trimmer is put in storage for thirty days or
more, follow the steps below to make sure the trimmer
is in good condition the following season.
trimmer:
Completely clean the trimmer
Put the trimmer in a building that has good ventilation.
NOTE: A yearly check-up or tune-up at an autho-
rized service dealer will ensure that the trimmer
will provide maximum performance for the next
season.
Engine:
IMPORTANT: It is important to prevent gum
deposits from forming in fuel system parts such
as the carburetor, fuel filter, fuel hose, and tank
during storage. Also, using alcohol blended fuels
(called gasohol, ethanol or methanol) can attract
moisture which leads to separation and formation
of acids during storage. Acidic gas can damage
the fuel system of an engine while in storage.
1. Drain all gasoline from the fuel tank. Let the engine
run until it is out of gasoline. If you do not want to
remove gasoline, add a fuel stabilizer to any gasoline
left in the tank. A fuel stabilizer will minimize the
formation of gum deposits and acids. If the tank is al-
most empty, mix the fuel stabilizer with fresh gasoline
in a separate container and add the mixture to the
tank. Always follow the instructions on the stabilizer
container. Run the engine at least ten minutes after
stabilizer is added to allow the mixture to reach the
carburetor.
. Drain the oil from a warm engine. Fill the engine
crankcase with new oil.
3. Remove the spark plug from the cylinder. Pour one
ounce of oil into the cylinder. Slowly pull the recoil
starter handle so that the oil will protect the cylinder.
Install a new spark plug in the cylinder.
4. Completely clean the trimmer including dirt and
debris from the cylinder cooling fins and the engine
housing.
5. When not in use, disconnect spark plug lead and store
in a well ventilated area inaccessible to children.
waRning
do not REmoVE gASoLinE WhiLE inSidE
A buiLding, nEAR A fiRE, oR WhiLE You
SmokE. gASoLinE fumES CAn CAuSE An
ExPLoSion oR A fiRE.
tRoubLEShooting & REPAiR
At Ardisam, we build quality and durability into the
design of our products; but no amount of careful design
by us, and careful maintenance by you, can guarantee
a repair-free life for your Earthquake String Trimmer.
Most repairs will be minor, and easily fixed by follow-
ing the suggestions in the troubleshooting guide in
this section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
For more complicated repairs, you may want to rely on
your retailer, an authorized service center or Ardisam,
Inc. A parts catalog is included in this section.
We will always be glad to answer any questions you
have, or help you find suitable assistance. To order parts
or inquire about warranty, call or write us at the address
found below, under the section ordering replacement
parts.
oRdERing REPLACEmEnt PARtS
Parts can be obtained from the store where the string
trimmer was purchased or direct from the factory. To
order from the factory- call, write or e-mail to:
Ardisam, inc.
1160 Eighth Avenue,
Cumberland, Wisconsin 54829
1-800-345-6007 • 1-715-822-2415
E-mail: info@ardisam.com
Please include the following information with your
order:
1) Part numbers
2) Part description
3) Quantity
4) Model number and serial number
