65 lb. Professional
Ice Melt Spreader
MODEL # 90365
ASSEMBLY INSTRUCTIONS
90365 65lb Ice Melt Spreader_M53107_113020
PAGE 4
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader. Do not use fertilizers or other lawn
chemicals in this spreader because it is not intended for use with these materials. If you have any questions please
contact EarthWay.
Move stop bolt on gauge assembly to the proper position for the material being applied.
While pushing spreader forward, push control lever forward to stop bolt
.
To stop, pull lever backward to close flow hole before you stop moving.
When finished, empty any remaining material from hopper.
Thoroughly was and dry your spreader and recoat with WD-40 before storing.
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND
CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16” WRENCHES AND 1 PAIR
OF PLIERS.
•
Clean the impeller plate after each use. Material build up on the impeller blades will cause uneven spreading.
•
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster
speeds will change the spread patterns. Wet material will also change the spread pattern and flow rate.
•
Clean your spreader thoroughly after each use. Wash between the shut off plate and bottom of the hopper.
•
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
•
When using Rock Salt remove salt from the hopper daily. Rock Salt will reconstitute back into a solid block over night
with humidity. As a preventative measure, spray all metal parts thoroughly (inside the tubing) with WD-40 or a spray
lubricant to prevent corrosion.
CUSTOMER SERVICE
574.848.7491 |
| 1009 Maple Street, Bristol, IN 46507
ONE YEAR WARRANTY
EarthWay Products, Inc. warrants this product free of defects in original workmanship and materials for a period of one year to the
end user with the original purchase receipt. If a manufacturing non-conformance is found, EarthWay Products, Inc. at its discretion
will repair or replace the part(s)/product at no charge provided the failure is not the result of incorrect installation, mishandling,
misuse, tampering, or normal wear and tear as determined by EarthWay.
EarthWay at its discretion may require that the part(s) or product be returned along with the original purchase receipt for
examination and compliance with the terms of this warranty. Do not return any product without first receiving authorization from
EarthWay Products, Inc.
To seek remedy under this warranty, contact EarthWay Products, Inc. at 574-848-7491, support@earthway.com or write to
EarthWay Products, Inc. 1009 Maple Street, Bristol, IN 46507 and describe the nature of the manufacturing defect. SPECIFIC
LIMITATIONS: This warranty covers only the part(s) or product; any labor charges associated with repair or replacement of
non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and ice melt products, EarthWay
Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure due to corrosion or
its effects.
