50 LB Ice Melt
Spreader
MODEL # 90950
ASSEMBLY INSTRUCTIONS
90950 – 50lb Ice Melt Spreader
PAGE 2
HELPFUL HINTS
Your ice melt spreader is almost ready to use. Attaching the CONTROL ROD and unfolding the handle will require a
pair of pliers to insert pins to secure the CONTROL ROD.
NOTE: The large opening is designed to allow ice melt to
flow through spreader without the need for an agitator. This unit is not designed for fertilizer
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster
speeds will change the spread patterns.
Prior to your first use, coat all metal parts (outside and inside of open-ended tubing) with WD-40 or other spray
lube to help prevent corrosion.
Clean your spreader thoroughly after each use. Wash with clean water and dry thoroughly and spray a light
coating of oil on all metal parts (inside open end of tubing) to help prevent corrosion).
Gears are permanently lubricated at the factory. Do not open the GEARBOX or dirt may enter.
PARTS LIST
HOW TO ORDER PARTS
Call or Email: TURF DEPOT 800-305-9255 or
earthway@turfdepot.com
