Warnings
Using instructions
■
Do not modify this appliance.
■
This appliance must be installed by an authorised technician or installer.
■
Prior to installation, ensure that the local distribution conditions (nature of the
gas and gas pressure) and the adjustment of the appliance are compatible.
■
The adjustment conditions for this appliance are stated on the label (or data
plate).
■
This appliance is not connected to a combustion products evacuation device. It
should be installed and connected in accordance with current installation
regulations. Particular attention should be given to the relevant requirements
regarding ventilation.
■
Before installing, turn off the gas and electricity supply to the appliance.
■
All appliances containing any electrical components must be earthed.
■
Ensure that the gas pipe and electrical cable are installed in such a
way that
they do not touch any parts of the appliance which may become hot.
■
Gas pipe or connector shouldn’t be bent or blocked by any other appliances.
■
Check the dimensions of the appliance as well as the dimensions of the gap to
be cut in the kitchen unit.
■
The panels located above the work surface, directly next to the appliance, must
be made of non-flammable material. Both the stratified surfacing and the glue
used to secure it should be heat resistant, to prevent deterioration.
■
Turn on appliance tap and light each burners. Check for a clear blue flame
without yellow tipping. If burners shows any abnormalities check the following:
-
Burner lid on correctly
-
Flame spreader positioned correctly
-
Burner vertically aligned with injector nipple
■
A full operational test and a test for possible leakages must be carried out by
the fitter after installation.
■
The flexible hose shall be fitted in such a way that it cannot come into contact
with a moveable part of the housing unit and does not pass through any space
susceptible of becoming congested.
■
Grease cranes produced at the factory to meet the requirement of all life hob.
V.1
15
