Electric Connection
The appliance has been manufactured as class I, therefore earth cable
is necessary.
The connection to the mains is carried out as follows:
IEC227
North America
L=live
Brown
Black
N=neutral
Blue
White
E=earth
Green/Yellow
Green
If the plug is not provided, connect the electrical load as indicated on
the description label. When a plug is provided, the cooker hood must
be installed in order that the plug is easy to access.
An omnipolar switch with a minimum aperture of 3mm between
contacts; in line with the electrical load and local standards, must be
placed between the appliance and the network in the case of direct
connection to the electrical network.
The minimum distance between the support surfaces of the cooking
pots on the cooker top and the lowest part of the cooker hood must
be at least 65 cm. If a connection tube composed of two parts is used,
the upper part must be placed outside the lower part.
Do not connect the cooker hood exhaust to the same conductor used
to circulate hot air or for evacuating fumes from other appliances
generated by other than an electrical source.
Before proceeding with the assembly operations, remove the anti-
grease filter (s) (Fig.5) so that the unit is easier to handle.
In the case of assembly the appliance, in the suction version prepare
the hole for evacuation of the air.
FIXING TO THE WALL
Drill the holes A respecting to the distances indicated (Fig.2).
Fix the appliance to the wall and align it in horizontal position to the
wall units. When the appliance has been adjusted, fix the hood using
the screws A.
For the various installations use screws and screw anchors suited to
the type of wall (e.g. reinforced concrete, plasterboard, etc.). If the
screws and screw anchors are provided with the product, kindly
check the screws are suitable for the type of wall in which the hood is
to be fixed.
V.1
6
