User Manual for the easichange
Replacement Series:
Ei141EK - Ionisation
Ei144EK - Heat
Ei146EK - Optical
Ei161EK - Ionisation
Ei164EK - Heat
Ei166EK - Optical
Congratulations!
You have purchased a genuine Easichange
replacement smoke/heat alarm kit containing an OEM Ei
Electronic alarm head.
This replacement kit contains everything you need to easily,
quickly and safely replace your mains powered, Ei Electronics /
Aico smoke or heat alarm.
Removing the Existing Alarm
1. Disconnect the mains power
Warning!
Before the existing alarm is removed, the mains power
must be disconnected.
Look on your mains distribution board for a switch marked
“Smoke Alarms” or similar and switch this off. If there isn’t a
switch marked with a recognisable label, switch the mains
power off.
Note:
This will cut power to everything in the house including
the lights.
Checking the New Alarm
9. Checking the indicating lights
Once the new alarm has been
connected and the mains power has
been restored it is important to check
the indicating lights.
If the alarm is working correctly
the
GREEN LIGHT
should be on
constantly and the
RED LIGHT
should flash once every 40 sec.
10. Testing the alarms
Press and hold the test button for
10 seconds, the alarm should sound
loudly.
If there are other connected alarms
in the house these should also
sound within 10 seconds of the test
button being pressed.
Any Problems?
If you have any problems fitting your new alarm, please give us
a call on:
0800 612 6537 or email support@easichange.co.uk
Doc 1129 - V1.0
