- 34 -
PCD
- tool positioning for Pitch Circle Diameter
ES-12 provides the PCD function for tool positioning for the drilling of the pitch holes along a
Circle, operator simply enter the machining parameters as per the step by step guide that
shown on the DRO's message display, then the DRO will calculate all the pitch holes position
coordinate, and temporarily preset those holes' position to zero ( 0.000, 0.000 ).
Operator simply move the machine until the X,Y axes display = 0.000, 0.000,
then the Pitch Holes' position are reached.
Machining parameters :
- Centre (
CENTRE
) ......................... X=0.000, Y=0.000
- Diameter (
DIA
) ............................. 80.000 mm
- No. of holes (
NO. HOLE
) .............. 5 holes
- Start angle (
ST. ANG
) ................... 30 degree ( clockwise )
- End angle (
End ANG
) ................... 300 degree ( clockwise )
after the above machining parameters are entered into the
DRO, the PCD function will temporarily preset all Pitch Holes'
position = ( 0.000, 0.000 )
operator can press or keys to select the Pitch Holes,
and move the machine to
display = ( 0.000, 0.000 ), then
the Pitch Holes' position along a
circle is reached.
Function :
Angular direction
positive( + ) - clockwise
negative( ) - counter
clockwise
X(+)
Y(+)
Example
Machining parameters :
- Centre (
CENTRE
)
- Diameter (
DIA
)
- No. of holes (
NO. HOLE
)
- Start angle (
ST. ANG
)
- End angle (
End ANG
)
CENTRE
DIA
ST. ANG
ENd ANG
( 300 degree )
( 30 degree )
( X =0.000
Y =0.000 )
( 80.000 mm )
Step 1
: Setup the work piece datum ( work piece zero ), press to enter into the
PCD
function
set up the work piece datum
enter into
PCD
function
enter the
CENTRE
coordinate
X
Y
Z
ABS
CENTER
PCD
Y
X
0.000
0.000
CENTER
X
Y
Z
ABS
mm
mm
mm
-78.560
45.675
12.345
Summary of Contents for ES-12
