MGI Zip X3
User Manual
17
16
8.0 Adjusting and Aligning
the Front Wheel
Each Zip X3 is checked for straight tracking prior to leaving the
factory. In the unlikely event the Zip X3 is not tracking straight, the
front wheel can be adjusted to regain straight tracking as follows;
1. Lock the swivelling front wheel [6.0] and run the Zip X3
forward to see if the Zip X3 veers left or right.
2. Unlock the swivelling front wheel, swivel it to see the locking
latch in the middle of the two front wheels, as below Picture
on Left
3. Unlock the latch by pulling down
4. Adjust the direction by turning the thumb screws in the right
hand Picture. Alternate between cogs when adjusting -
suggest a quarter of a turn at a time
– To make the Zip X3 go Right - L/H screw anticlockwise,
R/H screw clockwise – [Up on both sides]
– To make the Zip X3 go Left - L/H screw clockwise,
R/H screw anticlockwise – [Down on both sides]
5. Lock the latch by pushing it up.
Please note that there is a process in adjusting the tracking. It is
suggested that the users should do a little bit of adjustment, test
the tracking and then adjust again until the Zip X3 goes straight.
9.0 Warranty
9.1 Warranty Policy
The MGI Zip X3 is covered by a limited 2 year manufacturer’s
warranty from the date of purchase. Duration of this warranty is:
– 2 years on parts*
– 2 years on Lithium batteries and chargers
*MGI or an authorised service centre will repair or replace any
parts found to be defective in materials or workmanship under
normal use provided that:
1. The MGI Zip X3 has been properly used, maintained and
regularly serviced [see section 10.5]
2. The replacement or repair is performed by an authorised MGI
service centre or the owner with MGI approval.
3. The Zip X3 has been registered online.
Our goods come with guarantees that cannot be excluded
under Consumer Law. You are entitled to a replacement or
refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled
to have the goods repaired or replaced if goods fail to be
of acceptable quality and the failure does not amount to a
major failure. This warranty is in addition to other rights and
remedies available to the consumer under law. The consumer
is responsible for expenses associated with a warranty claim. To
make a warranty claim, cease using the goods immediately and
contact MGI directly using the contact details on the back of this
User Manual. Proof of purchase is mandatory.
Summary of Contents for MGI zip Series
Page 2: ......