Device Management
NVR User Manual
78
mask of the internal ethernet port can be changed to make the port in the same network
segment with the IP cameras which directly connect to the PoE ports of the NVR (it is not
recommended to change the IP address and subnet mask of the internal ethernet port).
Multiple Ethernet Ports Setting
If the NVR has two network ports or above, you can select the network work pattern as
required. Network Fault Tolerance and Multiple Address Setting are available.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the “Network Fault
Tolerance” pattern. There are many advantages of this work pattern: 1. increase the bandwidth;
2. form a network redundant array to share the load. When a failure happens to one network
port, the other port will take over the entire load immediately. The takeover process is seamless
and the network service will not be broken off.
Refer to the figure as shown below. If “Network Fault Tolerance” is selected, check “Obtain an
IP address automatically” and “Obtain DNS automatically” to get the IP address and DNS
automatically, or manually input the IP address, subnet mask, gateway and DNS; select one
Ethernet port as the primary card and then click “Apply” button to save the settings.
Summary of Contents for 23SE-S
Page 22: ...Wizard Main Interface NVR User Manual 17...
Page 59: ...Record Disk Management NVR User Manual 54...
Page 108: ...FAQ NVR User Manual 103 Fig 11 1 Fig 11 2...
Page 111: ...450011000729 A4...
