Plasmasonic
®
DRSSTC Instruction Manual
December 2019, REV -
− 48 −
http://www.EasternVoltageResearch.com
Plasmasonic
®
1.3 DRSSTC Instruction Manual
8. The RGB LED Illumination board has a single MODE pushbutton which
allows the user to control the operation of the illumination and to select the
various illumination modes. The table below summarizes the functions of the
MODE select pushbutton. Use the pushbutton as required to make the
illumination changes you require. Please note, that any changes you make will be
stored in a non-volatile memory that will be remembered the next time the unit is
powered up.
Function
Pushbutton Action
Description
Illumination Mode Change
Double PB Press
Pressing the pushbutton two quick
times in succession will cause the
illumination mode to cycle to the next
mode of operation.
Pause Animation
Single PB Press
Pressing the pushbutton once will
cause the illumination animation to
pause. Pressing the pushbutton once
again will unpause the animation.
Turn OFF Illumination
Hold PB for 2 seconds
If the illumination is active, holding
the pushbutton for approx. 2 seconds
will turn the illumination OFF.
Turn ON Illumination
Hold PB for 2 seconds
If the illumination is off, holding the
pushbutton for approx.. 2 seconds will
turn the illumination ON.
