EW-ECO SERIES OPERATION MANUAL
27
Length of line, there is less
than or equal to the set
length
1
、
the wire itself line thickness a.
2
、
a rolling wheel with dirt, required to be cleaned. The conductor surface
wax, lead into, wire wheels slip with sticky wax, wire brush, and gasoline
cleaning four rolling wheel.
3
、
take out wire, level “ 00 ” air operation phenomenon, be excluded.
4
、
the wire laying frame having card hysteresis phenomenon, leading to poor
conveying wire.
Head and tail cut or no cut
1
、
check the head or tail of sevred, wire diameter is too small, should adjust
the “ wire ” bigger. ( a reference value 30-90 )
2
、
Checking thread tail no cut marks, wire diameter is too lare, should adjust
the “ wire ” smaller. ( a reference value 30-90 )
Sometimes the head or tail
was cut off
1
、
wire wheel, the pressure is not enough, please check and regulation of
“ round round pressure regulating knob ”, make the pulley pressure
becomes great.
2
、
the line wheel clearance is too large, need to adjust the “ into the line
wheel clearance adjustment knob ”, the line wheel clearance reduction.
There are several strands of
wire long thread
1
、
wire diameter is too small, the cut wire, strip with a copper wire, to
increase the diameter of 1-2, try again.
2
、
retreat knife set too small, it should be increased the retracting parameters
(00-10 )
Sometimes the conducting
wires together no knife
broken
1
、
the edge parts activities with the ordinary oil, try again (usually 8 hours
filling a ).
2
、
the speed is slow.
3
、
check the wire specifications in AWG12# line ( 3 square ).
4
、
the blade is blunt, flat grinding, or replacement.
5
、
according to the seventh part of the third inspection.
Press run after shutdown can
only cut a, screen appears
“ short line or knot ”
1
、
no line of automatic shutdown function, belongs to the normal.
2
、
setting the length should be greater than 32 mm ( except for the 98
procedures ).
3
、
wire wheel clearance is too large, is required for the regulation of “ round
round gap adjustment knob ” make the pulley reduced gap.
When the power is switched
on the fan to work normally,
screen normal, but according
to “ run ” after the machine
can not move
1
、
because of the voltage instability or illegal operation of the circuit board in
the insurance pipe burn, need to replace the fuse ( open the case cover,
visible in the circuit board has two 5A insurance tube ).
2
、
such as changing insurance tube, continue to burn out, and my company
customer service service department or office contact.
Incision inclined tangent
1
、
wire itself is too curved, the purchase of a straightening device.
2
、
a lead mouth without facing edge center.
3
、
a tail tilts, inspect the wire pipe is leaning against the tool too close.
