EW-ECO SERIES OPERATION MANUAL
6
Fast operation example
1.Strip and cut 35mm2 copper wire of 7 strands, total length 150mm,
head stripping 20mm, tail stripping 20mm: set up as follows:
2. Strip and cut 50 mm2 copper wire of 19 strands, total length 150mm,
head stripping 20mm, tail stripping 20mm, change the parameter in above
picture: knife value from 435 to 500; knife retreat from 85 to 90.
The above parameters are for reference only and specific set-up will still
depend on processing wire.
Note: The small of the knife value is , the deeper of the cutting is; the
thicker of the wire is, the larger of the knife retreat value should be. The
following table is the reference parameter data for the set-up of knife
value and knife retreat value: