8
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
OPERATION
• Adjust the Platen Table to the desired
angle of the sanding or grinding
project
(FIG 6).
• Always verify with a square for 90° or
protractor for other angles
(FIG 7)
.
• Using the Miter Fence, secure the
workpiece and, if desired, adjust
the angle of the sanding or grinding
project
(FIG 8)
.
• Plug the Power Cord into the nearest
120 V~, grounded, 20 Amp electrical
outlet. Be sure the power cord is away
from and out from under the Grinding
Disk.
FIG. 6
FIG. 7
FIG. 8