To order parts and supplies: 800.343.9353 >> eastwood.com
5
4) POWER TOOL USE AND CARE
a)
Do not force the power tool. Use the correct power tool for your application. The correct power
tool will do the job better and safer at the rate for which it was designed.
b)
Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and must be repaired.
c)
Disconnect the plug from the power source and/or the battery pack from the power tool before
making any adjustments, changing accessories, or storing power tools. Such preventive safety
measures reduce the risk of starting the power tool accidentally.
d)
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e)
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the power tools operation. If damaged, have the power
tool repaired before use. Many accidents are caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits etc., in accordance with these instructions and
in the manner intended for the particular type of power tool, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
ADDITIONAL SAFETY INFORMATION
READ INSTRUCTIONS
• Thoroughly read and understand these product instructions before using the
Sander/Polisher.
• Keep these product instructions for future reference.
SHOCK HAZARD!
• Never operate or store Sander/Polisher in damp or wet conditions.
• Plug into a minimum 15 amp properly grounded circuit. If using an extension
cord, it must be AWG 14 or greater, no longer than 25’.
