To order parts and supplies: 800.343.9353 >> eastwood.com
13
STARTUP PROCEDURE
Refer to the Control Panel
(FIG 20)
:
1.
Check that the Chuck Key is removed form the Chuck (when in drill configuration)
2.
Check that the Power Cord is unplugged from the power source.
3.
Verify that the Spindle Motor “ON/OFF/ Speed Control” Switch is OFF.
4.
Check that the STOP Button is not activated.
5.
Verify that the Plastic Chip Guard is in position over Spindle.
6.
Shift the High/Low Speed Lever
(FIG 21)
to the selected position.
7.
Plug power cord into Properly Grounded 120VAC, 60hz receptacle.
8.
Set the Spindle Motor “ON/OFF/ Speed Control” Switch to the “1” position.
9.
Rotate the Speed Control Knob to approx. 20%. The Spindle should now rotate.
10.
Set the RPM Spindle Motor “ON/OFF/ Speed Control” Switch to the correct speed
for the operation being performed.
11.
Always use the Spindle Motor “ON/OFF/ Speed Control” Switch to stop the Mill.
FIG. 20
FIG. 21
NEVER attempt to shift from HIGH to LOW range while the Mill is
running otherwise severe drive train damage will occur.
The Plastic Chip Guard is an important safety feature and should
be checked frequently for physical damage and proper function.
INJURY HAZARD!
ALWAYS turn the Mill OFF at the ON/OFF/SPEED CONTROL Switch
and unplug the power supply cord BEFORE changing ANY settings
or making ANY adjustments. This includes shifting from High to
Low range.
If at any time the Amber Light is illuminated, this indicates a Fault
condition and the Mill will not run. Potential Fault causes are:
- The Mill was overloaded.
- The Mill was stopped by depressing the Emergency Stop Button.
- Loss of power to Mill while in operation.
