background image

To order parts and supplies: 800.343.9353  >>  eastwood.com 

3

 

 READ INSTRUCTIONS 

•  Thoroughly read and understand this manual before using. 
•  Save for future reference.

 

PINCH AND CRUSH HAZARD!

•  The Eastwood Metal Hand Punch presents a hand/finger pinch hazard and 

cause potentially serious injuries. Avoid pinching fingers and hands while 
handling and operating.

 

CUT HAZARD!

•  Handling sharp metal can cause serious cuts. Wear thick, well-fitting work 

gloves to prevent cuts from handling sharp metal.

 

EYE INJURY HAZARD!

•  Metal particles can be ejected from the tool when punching.  

Sheet metal edges and corners are sharp and can injure eyes.  
Always wear ANSI approved eye protection when operating this tool.

 

•  Strenuous physical force may need to be applied to the Metal Hand Punch 

during use. Failure to ensure proper footing can quickly result in a fall which 
could inflict serious personal injury or property damage. Always work in a 
clean, uncluttered environment.

 

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.

 

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

 

CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided, 
could result in minor or moderate injury.

 

NOTICE is used to address practices not related to personal injury.

SAFETY INFORMATION

The following explanations are displayed in this manual, on the labeling, and on all other information 
provided with this product:

Summary of Contents for 32559









Reviews: