4
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
SAFETY INFORMATION
• Excessive resistance while operating could indicate a defect with the
workpiece material or broken or damaged Metal Hand Punch components.
To avoid injury, stop work immediately and inspect workpiece material for
nicks, dents, welds, excessive scale or remaining coatings. Clean or repair
as necessary or discard and begin with a new piece. Also inspect Metal
Hand Punch components for looseness or damage.
DIE INSTALLATION
AND REPLACEMENT
• Using the blade end of the Die Installation Key,
unthread and remove the Anchor Pin
(FIG 1)
from the Anchor Arm and Main Body Pivot.
• Rotate the Upper Handle upward and pull the
Anchor Arm backward
(FIG 2)
.
• Slip the Male Punch Die upward through the
lower bore of the Main Body Lower Jaw with
the “T” Head up
(FIG 3)
.
FIG. 1
FIG. 2
FIG. 3
