RECHARGEABLE
COB LED PENLIGHT
INSTRUCTIONS
© Copyright 2020 Eastwood Automotive Group LLC 11/20 Instruction item #33934Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: tech@eastwood.com
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
Item #33934
OPERATION
• Place the base or back against any ferrous metal surface for magnetic attachment.
• Depress and release rectangular rubber button located at the housing once for High-Intensity
COB LED Illumination, 2nd time for Low-Intensity COB LED Illumination and a 3rd time for
the Flashlight.
• Depress Button once again to turn off.
CHARGING
• When the Indicator light above the
Charging Port illuminates RED, the
battery requires a charge. To do so:
- Flip up rubber seal and plug the
Type-C terminal of the included
Power Cord into the Type-C port on
the side of the housing
(FIG 1)
.
- Plug the USB terminal of the Power
Cord into a standard USB port with
5V 1A output.
- Allow 2 hours for full charge.
- Do not use Light while charging.
- The indicator light Indicator light above the Charging Port will glow RED while charging
then change to GREEN indicating full charge
(FIG 1)
.
- Do not leave Light on charge beyond 24 hours.
Batteries will automatically discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
FIG. 1
