To order parts and supplies: 800.343.9353 >> eastwood.com
7
GUN CLEAN-UP
• Disconnect air supply to gun.
• Pour unused coating into a proper disposal container and remove Paint Cup.
• Wipe out any excess coating then thoroughly rinse the Paint Cup with a mild solvent compatible
with the coating being used.
• Attach paint cup, then pour a small amount of a solvent, compatible with the paint being used,
in the Paint Cup, then run solvent through HVLP Gun in a safe area until it flows clear.
• Remove air supply from HVLP Gun.
• Pour out any unused solvent and remove paint cup.
• Allow solvent to dry completely from all components.
PAINT GUN DISASSEMBLY
FOR ADDITIONAL
CLEANING
• Remove Air Cap by unthreading and remov-
ing Retaining Ring
(FIG 5)
.
• Remove Nozzle with a 19mm wrench.
(included)
(FIG 5)
.
• Unthread and remove Fluid Control Knob
from rear of Paint Gun body
(FIG 6)
.
• Carefully remove Tension Coil Spring with
Bushing and Needle by firmly gripping rear
of Needle and pulling out through rear of
Paint Gun body
(FIG 6)
.
FIG. 5
FIG. 6
As an alternative, #12846Z Eastwood Aerosol Injected Gun Cleaner or
Eastwood Paint Gun and Equipment Cleaner are excellent for this purpose.
