2
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
To order parts and supplies: 800.345.1178 >> eastwood.com
3
operAtion
• Disconnect air supply from the wrench to prevent accidental starting and potential injury while
placing a socket on the 1/2” square drive.
• Install selected socket over the retaining ring on the square drive.
• To remove fasteners, rotate the knob on the rear of the gun body counter-clockwise to one of
the 3 positions. Speed and torque will increase in the reverse direction the more the knob is
turned counter-clockwise.
• To tighten fasteners, rotate the knob on the rear of the gun body clockwise to one of the
3 positions. Speed and torque will increase in the forward direction the more the knob
is turned clockwise.
• Connect air line and hold tool securely and depress the trigger to begin installing or removing
a fastener. Speed is regulated by pressure applied to the trigger.
mAintenAnce
• Add several drops of air tool oil before each use directly into the air inlet or use an
inline lubricator.
• If the tool is to be unused for an extended period of time, add 10 drops of air tool oil directly
into the air inlet. Rotate the motor by hand several times to distribute the oil throughout the
motor and then store the tool with the handle up.
troubleshooting
• Tool doesn’t respond to trigger depression:
- Verify sufficient air supply to tool.
- Check for moisture in air line and tool air inlet.
• Tool performance is slow or sluggish:
- Verify sufficient air supply to tool.
- Check for moisture in air line and tool air inlet.
• Tool emits excessive noise during use:
- Stop use immediately and add air tool oil directly to air inlet.
Delivers nut busting 600 ft lb max torque in a compact size that weighs only an incredible 3.5 lbs.
The impact tool is only 4.8 inch long and 2.4 inch wide, about 30 percent smaller and lighter than
leading brands offering greater access to tight spaces. Engineered to the finest detail, the tuned
exhaust controls noise output to 90 dB max. The ON/OFF trigger switch is well engineered to sense
minute pressure and react accordingly. The housing is full metal bodied and provides lasting durability.
Comfort grip provides slip free convenience and reduces fatigue. Features a six position power
regulator dial.
WArnings
• Do not exceed 90 PSI (6.3 bar) of tool inlet air pressure. Permanent tool damage and or
personal injury could occur.
• Hold tool securely as the tool body can suddenly kick back or twist causing severe hand or
wrist injury. Two-handed operation is recommended.
• Wear approved eye wear at all times when operating the tool for protection from possible
ejected metal chips.
• Keep loose clothing, jewelry, and long hair away from rotating components as serious personal
injury can occur.
• Always disconnect tool from air supply when changing sockets or accessories to prevent
accidental tool starting and potential injury.
• Always make sure the work piece is securely clamped or anchored to allow two handed
operation of the wrench.
• Use only specific impact rated sockets, adaptors and accessories.
• Do not use sockets adaptors or accessories that are broken or cracked.
specificAtions
• 1/2” Square Drive
• Maximum Torque: 600ft-lb / 815 Nm / 83 Kg-m
• Free Speed: 9,000 RPM
• Air Consumption: 4 CFM
• Inlet Thread Size: 1/4” NPT
• 3 Forward Speeds
• 3 Reverse Speeds
set up & connection
• Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
• A minimum 3/8” ID air line should be used for optimal performance.
• Add several drops of air tool oil before each use at the air inlet or utilize an inline lubricator.
