6
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
To order parts and supplies: 800.343.9353 >> eastwood.com
7
As an alternative, # 12846Z Eastwood Aerosol Injected Gun Cleaner
is excellent for this purpose.
CLEAN-UP
• Disconnect air supply to gun.
• Remove Paint Cup and pour unused coating into proper disposal container.
• Wipe out any excess coating, then thoroughly rinse the Paint Cup with a mild solvent compatible
with the coating being used.
• Pour a small amount of a solvent compatible with the paint being used in to the Paint Cup then
attach Paint Cup, run solvent through HVLP Gun in a safe area until it flows clear.
• Remove air supply from HVLP Gun.
• Pour out any unused solvent and remove paint cup.
• Allow solvent to dry completely from all components.
PAINT GUN DISASSEMBLY FOR ADDITIONAL
CLEANING OR REBUILDING
• Remove Air Cap by
unthreading and removing
Retaining Ring
(Fig 1)
.
• Remove Nozzle with a 10mm
wrench which is included
(Fig 2)
.
• Remove the tan plastic oval
shaped Air Manifold from
the front of the Gun Body
(Fig 3)
.
• Unthread and remove Fluid
Control Knob from rear of
Paint Gun body.
REASSEMBLY
• Set the tan plastic Air
Manifold into the oval shaped
recess in the front of the Gun
Body
(Fig 5)
.
• Replace Needle by sliding
into bore in rear of Paint Gun
body until it seats
(Fig 6)
.
• Slide Needle Tension Spring
w/bushing over the rear of
the Needle
(Fig 7)
.
• Replace Nozzle by threading
into front of Gun Body and
tighten firmly with included
10mm wrench (do not-over
tighten).
• Replace Air cap by threading
Retaining Ring onto Gun
Body. Make sure the air
horns of the Air Cap are
oriented properly.
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 7
• Carefully remove Tension
Coil Spring with Bushing and
Needle by firmly gripping
rear of Needle and pulling
out through rear of Paint Gun
body
(Fig 4)
.
FIG. 6
Nozzle
✓
R
em
ov
e
10mm
Tan
Plastic
Air
Manifold
✓
Needle
✓
Tension
Spring
✓
✓
Oval
Recess
✓
Needle
✓
Tension
Spring
✓
Tension
Spring
✓
✓
Needle
✓
