To order parts and supplies: 800.343.9353 >> eastwood.com
7
ASSEMBLY
1.
Place "D" Handle with curves facing forward and with ends over recessed areas of tool body.
2.
Insert 2 Socket Head Cap Screws through the holes in "D" Handle and into threaded holes in
tool body. Tighten screws securely.
OPERATION
1.
Set desired motor speed by rotating the Speed Knob located on the top surface of the
Motor Housing. To the left = Low (1), to the right = High (6)
(FIG 1)
.
2.
While holding the Contour SCT securely in two hands, depress the On-Off switch with
forefinger
(FIG 1)
.
IMPORTANT NOTE:
The built-in Soft-Start feature will cause a slight
delay in motor starting and gradually increase in speed. This feature is designed to eliminate
the possibility of the tool “pulling” at startup
3.
For extended use, lock the On-Off switch in the ON position. To lock the On-Off switch in the
ON position, depress the On-Off switch fully then push in the Lock Button located above the
Switch on the left side of the Handle. To release lock, depress the On-Off switch
(FIG 1)
.
4.
Keep the broad work surface of the Drum parallel to the work surface whenever possible to
minimize uneven wear and maximize usable life.
5.
Always use two hands while operating tool, do not force but allow the rotational speed of
the drum to do the work.
6.
Be sure that the workpiece is clamped down or held securely to always allow two hands
to operate tool.
NOTE:
Only use a speed fast enough to remove coatings and keep wheel
turning. Too fast will heat the metal.
Unplug unit before assembly.
Speed Knob
✓
On/Off Switch
On/Off
Switch-On Lock
(left side)
✓
FIG. 1
"D" Handle
✓
Socket Head
Cap Screw
✓
✓
