8
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
DRUM REPLACEMENT
REMOVAL
1.
Unplug Contour SCT from power supply
before beginning.
2.
Depress the Drive Lock Button on the left
side of the gearcase
(FIG 2)
.
3.
Place the included 8mm Hex Key Wrench into
the Socket Head Cap Screw on the right side
of the Drive Armature
(FIG 3)
.
IMPORTANT NOTE:
This is a
left hand
thread
, rotate in a
Clockwise
direction
to loosen.
4.
Pull the Drum outward to remove from the
Drive Armature.
NOTE:
A gentle pry with a screwdriver may
be required to release the Drum.
INSTALLATION
1.
Align 2 of the 4 internal splines of the Drum
with the 2 Keys of the Drive Armature and
slide it on.
NOTE:
The face of the Drum
should be flush with the outer end of the
Drive Armature when fully seated
(FIG 4)
.
2.
Replace the M8 Socket Head Cap Screw and
Washer by threading into the right side of the
Drive Armature.
IMPORTANT NOTE:
This is a
left hand
thread
, rotate in a
Counter-clockwise
direction to tighten.
FIG. 2
FIG. 3
FIG. 4
Drive Lock Button
✓
Left-Hand Thread
Socket Head Cap Screw
✓
Lo
o
se
n
Drum
Splines
Drive
Armature
Drive
Keys
✓
✓
✓
Unplug unit before replacing drum.
Never operate unit with Drum removed.
Severe injury could occur.
