To order parts and supplies: 800.345.1178 >> eastwood.com
7
MAINTENANCE
• Before each use, add a few drops of a quality air tool oil. (Not Included).
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air inlet
then store the tool, inlet up.
• With the air supply disconnected, periodically check that the belt is not worn, torn and is tight.
ADJUSTING BELT TRACKING
• Disconnect air supply from the tool to prevent accidental starting and potential injury while
adjusting the Abrasive Belt Tracking. The Tracking Adjustment Screw is located at the outer
right side of the Abrasive Arm Assembly
(FIG 6)
.
• Using the included 4mm Hex Key, turn the screw clockwise (as viewed from the right side)
will cause the belt to track left while turning the screw counter-clockwise will cause the belt
to track right.
INJURY HAZARD!
Disconnect air supply from the tool to prevent accidental starting and potential
injury while Adjusting Belt Tracking.
FIG. 6
Tracking Screw
✓
