12
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
AIR FILTER CHANGE
• Remove the Lid from the Air Filter Housing by rotating the Lid counterclockwise to unlock it
(FIG 6)
.
• Remove the Air Filter Element and discard it.
• Replace the Air Filter Element with a new Eastwood #31717 and re-install the Air Filter Housing Lid. Note that the peg of the Air Cleaner Cover must
be indexed with one of the 5 recesses around the circumference of the Filter Housing and the snorkel of the Air Cleaner Housing must be pointing
downward
(FIG 8)
.
BURN HAZARD!
Components are Hot! Significant heat is generated during operation. Allow to cool a minimum of 1 hour after last use before
servicing to avoid burns.
INJURY HAZARD!
Before performing any service, turn Power Switch to the “OFF” position (FIG 1). Shut off breaker or disconnect power supply.
Oil Filter
#31715
Moisture Separator
#31716
✓
✓
FIG. 15
FIG. 15
Used Oil is a polluting material and should be disposed of in
compliance with local regulations.
If any air or oil leaks are discovered, call Eastwood Tech
at: 1-800-343-9353.
• Install a new Eastwood #31715 Oil Filter (Black Canister) at the left position
of the Filter Manifold
(FIG 15)
.
• Install a new Eastwood #31716 Moisture Separator (White Canister) at the
right position of the Filter Manifold
(FIG 15)
.
• With the Oil Drain and Air Tank Drain Valves closed, turn the Power Switch
back to “ON”, allow full pressure to build until the Pressure Switch auto-
matically shuts the unit off then turn the Power Switch to “OFF”.
• Listen for any air leakage and observe the Scroll case, all lines and fittings
for any evidence of oil leakage.
