5 PROPER USE
HOW TO SETUP POSITIONS
The OX Telescopic Multi-ladder can be used in positions shown below with no additional equipment
required. The following instructions will demonstrate how to change the OX Telescoping Multi-ladder.
POSITION #1
TWIN STEPLADDER
1) To configure the OX Telescopic Multi-Ladder into
the stepladder position, follow the directions for
changing the angle of the ladder (Section 3) using
the push knob locking hinge.
Note:
The stepladder position is easiest completed
with the ladder standing up. In this position excess
pressure is not exerted on the hinge.
2) At this point the height of the ladder can be
changed to the desired height using the Spring
Loaded “J” locks and the instructions for them
(Section 4).
CAUTION
- For every position all hinges are supporting hinges and must be locked.
- Never straddle front and rear sections.
- Always face ladder and maintain firm grip while on it.
- DO NOT stand on or above second rung from top of ladder.
8
