aSSemBly InStruCtIonS
SteP 4: Bottom Side Braces
the Side braces attach to the inside faces of the back leg
(6)
and ladder
(7)
frames. insert t-bolts into the holes
in the bracket end plates and finger tighten 10mm nyloc nuts to the t bolts. insert the t bolt heads into the slots in
the ladder frame extrusion, twist clockwise to lock them and tighten the nuts firmly.
Note:
The Bottom side braces must be 90°to the back leg frame and the inside faces of the brace
end brackets must sit firmly against the inside faces of the ladder and back leg frames. (8)
SteP 5: mid Side Braces
On the WHdp07 and larger platforms, add a pair of second side braces midway between the bottom side braces
and the underside of the platform, attaching them to the frames using the same technique as the bottom braces,
with t-bolts fitted through the bracket end plates welded to the braces. attach 10mm nyloc nuts and tighten
firmly.
Note: The Mid Side braces should be 90° to the back frame and the inside faces of the brace
end brackets must sit firmly against the inside faces of the ladder and back leg frames.
SteP 6: Platform Guardrails
insert t-bolts into the holes in the handrail mount plates, attach and finger tighten 10mm nyloc nuts to
the bolts as in step 4. fit the side guardrail frames to the platform side extrusion by inserting the t bolt heads into
the slot in the extrusion as shown
(9)
,
(10)
. twist the t bolts clockwise and firmly tighten the nyloc nuts as in step
4. repeat this step for the guardrail on the opposite side of the platform
(11)
.
Note: Ensure the T-Bolts attaching to the back leg frame are tightened first (10).
attach entry gate to the post at the top of the ladder frame using the hardware already attached to the gate.
insert the end of the bolt into the receiving hole in the handrail post, fit the large washer and nyloc nut to the bolt
inside the post and tighten firmly. insert the cap into the top of the post to complete the gate assembly.
ensure the exit swing gate pin engages correctly with the receiving latch on the post.
SteP 7: ladder Guardrails
insert t-bolts into the bracket at the base of the ladder handrails
and attach and finger tighten nyloc nuts to the bolts. fit the head
of the t-bolts into the slot in the ladder frame extrusion at the
base of the ladder and twist the bolt anti clockwise to lock it into
the slot
(12)
, attach the top channel to the handrail post at the
top of the ladder
(13)
. fit the m8 x 55 bolt through the holes in
the channel and post and tighten the nyloc nut firmly. complete
the process by tightening the 10mm nyloc nuts firmly on the
t-bolts at the base of the ladder frame.
SteP 8: final adjustment
Stand the ladder on its feet and ensure all nuts are firmly tightened and the ladder is firm and level on
the support surface. ensure that the heads of all t bolts are locked into place within the extrusion.
6.
7.
8.
11.
9.
10.
Tighten
first
12.
13.
