Easy 600 Installation And Operating Instructions Manual Download

Page: 19 / 51

WARNING

Please read the operating instructions carefully before starting installation and use. The installation of your nine garage door opener must be carried
out by a competent qualified person or company. According to EN 12635, a competent person is a person who has the appropriate training, qualified
knowledge and practical experience to install, inspect and maintain a door system correctly and safely. Installation or repair without suitable tech

nical qualifications can lead to serious injury, death and/or damage to property.

Contents

Dear customer

Thank you for choosing a quality product of the Easy brand "made by Schartec". Thanks to our unique quality management system and continuous
product development, Easy garage door openers meet the highest standards of quality and convenience. We thank you for your trust and wish you
much pleasure with your new Easy garage door opener.

Declaration of conformity (CE)

Easy garage door openers meet the requirements of the applicable European and national directives. Conformity has been verified and the corre

sponding declarations, certificates, test reports and documents can be requested at info@schartec.de. The declaration of incorporation can also
be found on page 34. The supplied radio system type NB4 (art. no. ST601004) complies with Directive 2014/53/EU. The full text of the EU Declara

tion of Conformity is available at the following Internet address: www.schartec.de

Important safety instructions

1. Intended use

The garage door opener is intended exclusively for the impulse operation of spring-balanced sectional and up-and-over doors in the private/
non-commercial sector. Door systems that are located in the public area and only have a protective device, e.g. force limiter, may only be operat

ed under supervision. The garage door opener is designed for operation in dry rooms.

2. Non-intended use

The garage door opener must not be used for purposes other than garage door opener automation. Continuous operation and use in commercial
areas is not permitted. The opener must not be used on doors without fall protection.

Qualification of the fitter and installer

Only correct installation and maintenance by a competent/knowledgeable company or a competent/knowledgeable person in accordance with

the instructions can ensure the safe and intended functioning of an installation. According to EN 12635, a competent person is a person who has

suitable training, qualified knowledge and practical experience to correctly and safely assemble, inspect and maintain a garage door system.

4. Safety instructions for assembly, repair, maintenance and disassembly of the garage door system

DANGER!

Balancing springs are under high tension

Adjusting or loosening the balancing springs can cause serious injuries! For your own safety, only have work on the balancing springs of the door
and, if necessary, maintenance and repair work carried out by an expert! Never attempt to replace, readjust, repair or relocate the balancing
springs of the door or their brackets yourself. Also check the entire garage door system (joints, door bearings, cables, springs and fastening parts)
for wear and possible damage. Check for existing rust, corrosion, and cracks. Faults in the garage door system or misaligned doors can result in
serious injury! Do not use the garage door system if repair or adjustment work has to be carried out!

Mains voltage

In case of contact with the mains voltage, there is a risk of fatal electric shock. It is therefore essential that you observe the following instructions:
Electrical connections may only be carried out by a qualified electrician. The on-site electrical installation must comply with the relevant protec

tion regulations (230/240 V AC, 50/60 Hz). Disconnect the mains plug before carrying out any work on the opener.

WARNING!