32
Technical data
Easy 600
Easy 800
Power supply
230 - 240V, 50-60 Hz
Max. tractive force
600 N
800 N
Max. door area
10 m²
12 m²
Max. door weight
80 kg
120 kg
Max. door height
2250 mm
Opening speed
150mm / sec
150mm / sec
Power consumption
120W
160W
End position setting
Electrical
Transformer
Overvoltage protection technology
Radio frequency
433.92 MHz
Coding
Rolling Code
Storage capacity
20 Codes
Working temperature
-20°C - +50°C
Safety devices
Soft start & Soft stop, photocell
possible, warning light possible
Protection class
IP30
Troubleshooting
Error Message
Possible Cause
Troubleshooting
No response from the garage door opener
1.
There is no power.
2. Plug not inserted.
1.
Check the voltage at the socket of the
door opener.
2.
Carefully open the cover of the motor and
check whether all cables are connected.
System learning will not start.
Photocell connected incorrectly or is not rec
-
ognized by the motor.
1.
Check the connection of the photocell.
2.
Adjust the photocell correctly.
Automatic closing cannot be set.
Photocell not connected.
Connect the photocell. This function is only
possible with a connected photocell.
Opener opens and closes by itself.
Interference pulse / mounting next to the
power line.
The motor must not be installed in the im
-
mediate vicinity of a power line (electrostatic
charging).
Opener does not work.
End position open or closed set incorrectly.
Reset the end positions as described in the
instructions.
Garage door only opens. Garage door does
not close. The display briefly shows "lr" when
trying to close the operator.
When using a photocell or when activating
the photocell function without a connected
photocell.
1.
Check the photocell and make sure that
no obstacle interferes with it.
2. Deactivate the photocell function if no
photocell is installed. To do this, follow
the instructions.
Garage door does not close. Light on the oper-
ator flashes constantly.
The automatic closing function is activated,
the photocell function is activated, but no
photocell is connected.
1.
Check the photocell and make sure that it
is not obstructed.
2.
Make sure that the photocell is connected
correctly.
Garage door automatically moves back 15-40
cm instead of closing completely.
Automatic safety return. Because of an old and
incorrectly set garage door. Door not balanced
or springs old, weak or defective.
1.
Check the springs in every door position.
2.
Reset the end positions.
3. Increase the power for automatic reversal.
