Safety
11
− If the room temperature is below 32 °F (0 °C), empty the water tank. Freezing
water can damage the product.
− Never fill the water tank with water that is above 104 °F
(40 °C) to prevent discoloration or deformation.
− Only put water in the water tank; never put water in the other parts of the
product.
− Never put water into the product’s vapor discharge opening or vapor discharge
channel. Wipe wet areas on the product with a dry cloth.
− Do not put any metals, chemicals, or cleaning agents in the water tank.
Otherwise, humidification won’t work properly.
− Never remove residual water from the steam pipe when the product is switched
on. This can destroy the sensor.
− Do not move the product around too much if there is a lot of water in the water
tank. Otherwise, water may leak and can get into other parts of the product.
− Never attempt to clean the product by immersing it
in water, and do not use a steam cleaner to clean it. Otherwise, the product could
be damaged.
− Do not in any case place the product in the dishwasher. It would be destroyed as
a result.
− Stop using the product if its plastic parts exhibit cracks or breaks or are deformed.
Replace damaged parts only with corresponding original spare parts.
− Pefer to the “Cleaning” chapter.
Summary of Contents for 1094S2022
