Operation
14
Connecting the product
− Connect the product to a properly installed power outlet using the plug-in power
supply.
Switching the product on and off
The amount of humidification can be progressively adjusted with the control knob
1
.
1. Turn on the product by turning the control knob
1
clockwise. The control knob
1
can be used to adjust the intensity of the mist output.
− If the green LED
3
lights up, there is a sufficient amount of water in the water tank
5
.
− If the red LED
2
lights up, there is an insufficient amount of water in the water tank
5
.
2. To turn the product off, turn the control knob
1
counterclockwise until you hear a
„click“ sound.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the control knob
1
so the mist
rises up to be absorbed by the room air. If mist drops quickly, turn down the
control knob
1
until the mist is rising up.
A NOTE ABOUT HUMIDITY: To reduce excessive humidity or condensation,
especially in small rooms, leave the roomdoor open and adjust mist intensity
to the low output setting.
− Too much humidity in the room may allow moisture to accumulate on surfaces
wherebacteria and fungi can grow. Moisture that gathers may also damage
furniture andwalls, especially wallpaper.
Refilling with water
The integrated safety mechanism automatically stops the humidification
process when there is no water in the water tank
5
. The red LED
2
is on and
mist is no longer released from the mist outlet slot
13
.
1. To use the product again, pull the power supply unit
8
out of the socket and fill
the water tank
5
with water (see chapter “Filling with water”).
2. Insert the power supply unit into the socket and switch on the product (see
chapter “Switching the product on and off”).
Summary of Contents for 1094S2022
