Cleaning
21
4. Empty the dust container.
Always pay attention to the MAX line
17
for maximum capacity.
Immediately empty the dust container when it is full.
5. Wipe off the outside of the handheld vacuum with a dry or damp, well-
wrung cloth.
6. Dry all parts thoroughly.
7. Clean the dust container, dust filter and coarse filter with a damp cloth.
If necessary, clean them under running water. Then let them dry
thoroughly.
8. Clean the ventilation slots
15
with a soft brush.
9. Correctly put the filters back into the dust container after cleaning.
10. Attach the dust container back onto the handheld vacuum.
Make sure that the unlock button on the top and the tab on the bottom of
the handheld vacuum latch into the openings of the dust container.
Cleaning the floor vacuum
1. Make sure the handheld vacuum
12
is switched off and removed from
the holder
2
of the floor vacuum
1
(see chapter “Using the handheld
vacuum”).
2. Clean the suction opening
38
with a soft brush.
3. Wipe off the housing of the floor vacuum with a dry or damp, well-wrung
cloth.
4. Dry all parts thoroughly.
5. If there is a blockage in the hose
8
, press the side clamps
9
to detach its
upper end from the floor vacuum for easy cleaning (see
Fig. A
). Attach the
hose back to the floor vacuum when cleaning is done.
6. Check the condition of the roller brush
40
through the viewing window
10
.
If it is too dirty, remove it from the floor vacuum for cleaning.
To do so, push the locking bar
39
towards the unlock symbol (
). Remove
the locking bar and then the roller brush from the floor vacuum (see
Fig. I
).
7. Remove any coarse lint from the roller brush and clean it under running
water.
8. Dry all parts thoroughly.
9. Place the roller brush and the locking bar back into the floor vacuum. Push
the locking bar towards the lock symbol ( ) to secure it in place.
