Wire colors
Orange
White
Brown
Red
Red
Yellow
Wire usage
Connect with Accessory(ACC)
Connect with ignition 1 wire
Connect with ignition 2 wire
Connect with co12V
Connect with co12V
Connect with starter wire
Remark
See note 5,7
See note 2,4
See note 3,4
See note 1
See note 1
See note 6
NOTE (1-7):
1.If there is only one +12V wire in your vehicle ignition wire harness, then connect it with both +12V red wires
in ec002;
2.White ignition 1 wire: When turn the key to ON or ACC, this wire with electricity, when starting the car, this
wire still with electricity;
3.Brown ignition 2 wire: When turn the key to ON or ACC, this wire with electricity, when starting the car, this
wire will cut off power suddenly at the moment of starting the vehicle;
Once the vehicle is started, both white & brown wire are with electricity.
4.If there is only one ignition wire in your ignition wire harness, connect it with the white ignition 1 wire, no
need to connect the brown ignition 2 wire
5.If there are 2 ACC wire in your ignition harness, connect both ACC wires with orange wire in ec002.
6.If there are 2 starter wires in your ignition harness, connect both starter wire with yellow wire in ec002.
7. If your car is newer cars that no ACC( only ON & OFF), connect the orange ACC( Accessory) wire and
white ignition 1 wire in EC002 wire harness with ignition 1 wire in your vehicle.
2.ABC 3 color GWR (ground while running) wire (see Note 8) or shock sensor (see note 9)
connect with GWR(-) from bypass module
Connect with
EC002 ACC or
ignition 1
(ACC is recommend)
connect with chassis ground(GND)
You can also use a SPDT relay to generate a GWR wire and wiring method is the same but no need to
connect 87a on SPDT relay.
Wire colors
Yellow/black
The 1st row 10 pin wires
Wire usage
Turn signal light/parking light(+)
Turn signal light/parking light(+)
See central door locking installation
Remark
3.20-Pin wire harness
Brown
Brown
-10-
©
EASYGUARD
Electronics
.
All
right reserved.
-09-
©
EASYGUARD
Electronics
.
All
right reserved.
Note 8:
If the alarm equip with 3 color GWR wire, which is used to connect with immobilizer bypass wire or GWR
wire or status output wire
Connection method:
No need to connect orange wire for all below method:
Method 1: Cut off the car factory chip immobilizer wire into 2 parts, each end connect with the white
&yellow wire respectively.
Method 2: if there is GWR(-) wire, connect the GWR(-) wire with white wire and connect yellow wire with
chassis ground(GND)
Method 3:If there is key sense wire which require either ground(-) or po) wire, connect the key
sense wire with white wire and connect the yellow wire with chassis ground(-) or +12V respectively.
Note 9:
If the alarm is equip with shock sensor, then connect with shock sensor. If so, there will be no GWR wire
in the kit and you can use the SPST relay to generate a GWR wire. Method is as below:
3 color GWR wire
M A K
L E D
Shock sensor
If your kit is with 3 color GWR wire, then there is no shock sensor, vice versa.
1.6-Pin ignition wire harness
Main wire harness introduction
IMPORTANT: